IPv4 Proxy Connections and Dual Stack DNS
An IPv4 proxy can operate in an environment where hostnames resolve to both IPv4 and IPv6 addresses. The client-to-gateway path and gateway-to-destination path are separate boundaries. When evaluating Go2Proxy IPv4 proxy services, establish which boundary must use IPv4 before changing DNS or client settings.
This prevents a common diagnostic mistake: treating an IPv6 connection to a gateway as proof that the destination did not receive an IPv4 source, or drawing the reverse conclusion from one exit observation.

Name the required address family
A legacy client may require IPv4 connectivity to the proxy. An owned destination may require an IPv4 source for its allowlist. A project can need either condition or both.
Write these as separate acceptance criteria. A statement such as use an IPv4 proxy does not tell the operator which connection must be inspected.
Keep hostname-based configuration intact where that is the supported interface. A hostname can resolve differently over time for service operations. Hard-coding a currently observed address can create a new dependency that the provider did not promise to maintain.
Inspect resolution from the actual client environment
Check gateway resolution and connectivity from the worker that makes the request. A laptop and a hosted worker can have different resolver results and address-family preferences.
Record the runtime, resolved candidates relevant to the diagnosis and the connection outcome. Do not assume the first address printed by a lookup utility is necessarily the one the application chose.
If the client supports a documented address-family preference, use it only to meet a stated requirement and verify the result. Avoid system-wide changes that alter unrelated applications just to simplify one proxy test.
Observe the destination boundary separately
Use an owned diagnostic destination that can report the source of the actual request. Preserve that observation with the request time and non-secret configuration label.
Do not infer the destination-visible family from the gateway hostname alone. The provider's outbound path can differ from the client's connection to the service.
If the destination itself offers multiple address families, document which endpoint the task intended to test. A successful request to one endpoint does not necessarily establish compatibility with another.
Separate family failures from other errors
A connection refusal, DNS failure, authentication rejection and certificate error are different results. Changing IPv4 or IPv6 preference is not a general remedy for all of them.
Retain certificate hostname verification. Replacing a gateway hostname with a literal address can change the identity being verified. Use supported configuration rather than weakening verification to accommodate an improvised address substitution.
Keep retries bounded. If a required family is unavailable in the deployment environment, preserve that incompatibility and fix the supported route rather than repeatedly generating requests with no new diagnostic information.
A dual stack interpretation example
Suppose an application connects to the proxy gateway over IPv6, while an owned diagnostic destination records an IPv4 source. If the requirement is an IPv4 source at the destination, the client connection alone is not evidence of failure.
If the application instead has a legacy requirement for an IPv4-only gateway path, that needs its own test and supported client setting. The same observations can satisfy one requirement while leaving the other unverified.
Report both boundaries explicitly. This avoids contradictory support messages in which one person reports the gateway address and another reports the exit, each believing they are describing the same connection. The guide to proxy DNS resolution provides the background for checking which component resolves each hostname.
Dual stack proxy questions
Does an IPv6 gateway connection imply an IPv6 exit?
Not necessarily. Observe the destination-visible source separately and compare it with the service arrangement.
Should a gateway hostname be replaced with its current IPv4 address?
Only if literal-address configuration is explicitly supported and meets the application's requirements. A temporary DNS result is not automatically a stable endpoint contract.
Can a DNS lookup prove which connection the application chose?
Not by itself. Client selection and runtime behavior matter. Use connection evidence from the process actually performing the task.
Keep the two boundaries visible
A precise IPv4 proxy test states the family needed at each boundary and the evidence used to verify it. That makes dual stack deployments easier to support without unnecessary network-wide changes.



